The reason why more customers choose the magnetic phone holder with car vent design is that it can solve these problems: 1. Unlike the sticky car mount (which takes 1-2 days to solidify), the car hook and clip magnetic phone mount can be used after installation. 2. The rubber pads attached to the car brackets will melt due to the high temperature in summer and leave residues, which cannot be stable in the car for a long time and damage the car body leather. 3. The special polycarbonate material of the hook clip is resistant to high and low temperature and prolongs the service life for 5 years.

Magnetic car holder mount are more convenient and stable. 1.When the phone is close to the mount, it will automatically attach. Simply snap! 2.By upgrading from 4 to 6 magnets, we break the market norm and enhance magnetic force and stability by 50%. The use of the clamp arm holder is troublesome because of the many steps: 1. Put the phone on. 2. With one hand, grasp the clamp arm. 3. Press the button before releasing. 4. Take out the phone.

Super easy installation: You extended the hook out as far as it could go. Pushed it into the air vent. Made sure it was hooked onto one of the individual slates. Turned the knob to tighten/secure it. KINDLY

NOTE:

• MagSafe cannot be used with these metal plates.
• Please place the metal plate on the back of the phone without case.
• Please attach the metal plate to the back of the phone or the phone case when using one.
• These metal plates are only intended for smooth, flat surfaces; they are not intended for use with leather, hefty cases, liquid silicone, or surfaces that are uneven.
• It is not advised to put an iron sheet between the back of a phone or tablet and its case;
• If the back of the phone, tablet, or case is made of glass, clean it first, then adhere the PE film and iron sheet;
• Only horizontal air vents can be used with this car phone holder; vertical, round ones cannot be used.